Axis P3304 Manuel d'utilisateur télécharger pdf (Page 6)

AXIS P3304/-V - Product overview

Microphone - built-in microphone. This can be disabled by inserting a plug in the 'Audio in' connector.

Power Connector - for connection of the PS-H power adapter (included).

I/O Connector - the I/O terminal connector provides the physical interface to

one transistor output, one digital input and an

auxiliary connection point for DC power. For more information, see The I/O Terminal Connector, on page 41.

Network Connector - the camera connects to the network via a standard network connector. Supporting NWay, the camera

detects the speed of the local network segment (10BaseT/100BaseTX Ethernet). Supporting PoE (Power over Ethernet), the

camera can be powered directly from the network cabling.

Audio Out - audio output (line level), which can be connected to a public address (PA) system or an active speaker with a

built-in amplifier. A pair of headphones can also be attached. A stereo connector must be used for the audio out.

Audio In - a 3.5 mm input for a mono microphone, or for a line-in mono signal (a stereo signal from line-in uses the left

channel).

Serial Number Label - the serial number may be required during installation.

Control Button - press this button until the status LED blinks green to install the camera using an AVHS service (see page

34), or the AXIS Internet Dynamic DNS Service

described on page 35. To restore the factory default settings using the control

button, follow the instructions Resetting to the Factory Default Settings, on page 4

LED indicators

LED Color Description

Network Green Steady for connection to 100 Mbit/s network. Flashes for network activity.

Amber Steady for connection to 10 Mbit/s network. Flashes for network activity.

Unlit No connection.

Status Green Shows steady green for normal operation.

Note: The Status LED can be configured to be unlit during normal operation, or to flash

only when the camera is accessed. See the online help files for more information. Go to

Setup > System Options > LED settings

Amber Steady during startup, reset to factory default or when restoring settings.

Red Slow flash for failed upgrade.

Power Green Normal operation.

Amber Flashes green/amber during firmware upgrade.

1 2 3 4 5 6 7 8 9 10 11 ... 57 58

Pas de commentaire

Axis P3304 Manuel d'utilisateur Page 6