Axis AXIS USB Manuel d'instructions télécharger pdf (Page 62)

update.

Firmware Recovery

For any reason that HyCncFlash.exe fails to run properly in normal mode,

firmware recovery need to be performed to force re-programming a correct

firmware that can recover the normal working condition. First, disconnect

HyCNC-4P from the PC’s USB. Then connect a 7-10V DC voltage source (i.e. using

a 9V battery) between EStop (pin 10) and the ground (pin 18-25), as shown in the

following drawing.

Connect HyCNC-4P to PC USB. If the firmware update mode USB driver has not

been installed, the driver install process starts automatically (described in the last

section). After the driver is installed, run HyCncFlash.exe to normally. After

update process starts, the external DC voltage source can be removed. After

updating process is finished, the HyCNC-4P should work properly.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 68

Pas de commentaire

Axis AXIS USB Manuel d'instructions Page 62