Axis AXIS USB Manuel d'instructions télécharger pdf (Page 58)

When firmware update process finishes, the following window pops up. Click

“OK”.

When the firmware update process runs the first time on a PC, HyCncFlash.exe

can’t run properly because the firmware update USB driver has not been installed.

The following failure windows will appear. It is normal. Click “OK” to end

HyCncFlash.exe.

“New Hardware Wizard” window pops up. Click “Yes, this time only” and “Next”.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 67 68

Pas de commentaire

Axis AXIS USB Manuel d'instructions Page 58