Axis AXIS USB Manuel d'instructions télécharger pdf (Page 33)

Outputs”. Put a green tick on the “Spindle” row’s “Enabled” column. All other

columns are not used by HyCNC-4 P.

Then click on page “Spindle Setup” page. If there is no circuit to control spindle

rotating direction. Put a “X” on “Disable Spindle Relay”. If spindle’s rotating

direction can be controlled by a H-bridge consisted by 2 relays, 2 relay outputs

are needed. If spindle’s rotating direction can be controlled by a H-bridge

consisted by 1 relays, 1 relay outputs are needed and the other is set to the

undefined output. The PWM1 and PWM2 base frequency is calculated by

equation

25000 x 10

“PWM base Freq”value

The PWM1 and PWM2’s duty cycle is controlled by the hardware. Its accuracy is

has nothing to do with “Kernel Speed”.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 67 68

Pas de commentaire

Axis AXIS USB Manuel d'instructions Page 33