Axis 210/211 Manuel d'utilisateur télécharger pdf (Page 9)

AXIS 210/211 - Before Installation

Before Installation

Follow these steps to install the AXIS 210/211 on your local network (LAN):

1. Familiarize yourself with the camera - see the overview on page 7.

2. Position and mount the camera as required - see below.

3. Connect the cables - see below.

4. Assign an IP address - see Select Your Installation Method, on page 10.

Mounting

1. If required, use the 3 supplied screws

to fix the base plate to a flat surface.

2. To use the shorter stand, remove the

extension section.

3. Attach the camera to the top of the

stand.

4. Adjust the camera angle and gently

tighten the lock ring.

Important!

Cable Connections

1. Connect the AXIS 210 to your network using a standard RJ-45 network cable. If using

Power over Ethernet (PoE) with the AXIS 211, this is the only connection required. Step

2 can be skipped.

2. Connect the power adapter to the camera.

The AXIS 210 is designed for indoor use only, and must always be positioned where it is not exposed to

direct sunlight or strong halogen light, which can cause permanent damage to the camera’s image sen-

sor. Damage as a result of exposure to strong light is not covered by the Axis warranty.

To use the AXIS 211

outdoors it must be installed in an approved outdoor enclosure. Please visit

www.axis.com for more information on enclosures.

Extension

section

Lock ring

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 49 50

Pas de commentaire

Axis 210/211 Manuel d'utilisateur Page 9