Axis AXIS USB Guide de l'utilisateur télécharger pdf (Page 81)

Configuring Drives (Dual Drive Units Only) 78

Maxtor Central Axis Admin User Guide

Replacing a Failed Drive (Central Axis Only)

It doesn’t happen often, but occasionally a drive in your Central Axis may fail. A failed drive

must be replaced if you want to continue to have full use of your Central Axis.

Identifying a Failed Drive

The Central Axis drives are identified by either a square symbol or a triangle symbol. Be

sure to note the symbol for the failed drive so you’ll know which drive to replace:

In order to replace the failed drive, you’ll have to shut down your Central Axis. Before you

do that, you can print a hard copy of the Drive Replacement instructions, as shown in the

steps below, or you can insert the Maxtor Central Axis Installation CD and read the

instructions provided in the PDF of the Maxtor Central Axis Admin User Guide.

If a drive fails, Failed Drive notification appears at the top of every Central Axis admin web

page:

Figure 119: Failed Drive Identification

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 121 122

Pas de commentaire

Axis AXIS USB Guide de l'utilisateur Page 81