Axis M7014 Manuel d'utilisateur

1 Model: TZT9/14/BB Axis IP Camera (H.264) Settings

10 Note: When the webpage loads, pay attention to the top of the page to authorize the installation of the ActiveX®. Click on the yellow bar and ch

11 [Compression] to [30] and click on [Save]. In this example, [640x480 (4:3)] is selected as the resolution, because this is the maximum resolution

12 Note: It is recommended to zoom in on the image to have a better “Home” preset. When the view is correctly set up, type “Home” for the Current pos

13 5. Setting up Axis Video Server 5-1. Setting up IP Address of Axis Video Servers To work with NavNet TZtouch, an Axis video server must be set u

14 5-2. Configuring Axis Video Server As with Axis IP cameras, Axis video servers must also be configured using a Web browser. 1. Enter the IP addr

15 6. In [Basic Setup] – [3 Date & Time], select [Synchronize with computer time] and click on [Save]. 7. In [Basic Setup] – [4 Video Stream] –

16 8. In [Basic Setup] – [4 Video Stream] – [Video 1] to [Video 4] and [Quad Stream] – [H.264] tab, set as follows. 6. Showing Camera Images T

17 6-2. Checking Axis Video Server(s) in Menu 1. After the interconnection and setup of video servers is complete, confirm they are detected in the

18 7. Tips – 4 x IP Cameras + 2 x Video Servers A maximum of four (4) sets of IP cameras and two (2) sets of video servers are available in one TZto

19 Note: A maximum of two (2) screens can be allocated to the Camera view in the 3-split screen mode on a TZtouch MFD. Select one of these sources in

2 INDEX 1. Introduction – v3.01 with H.264 2. Overview 2-1. Summary – Setup Procedure 2-2. Latest Axis Cameras Compatible with H.264 Format 2-3. Test

3 1. Introduction – v3.01 with H.264 In addition to MPEG-4, the TZtouch v3.01 software is also compatible with H.264 format, which offers a wider se

4 2-2. Latest Axis Cameras Compatible with H.264 Format To find the latest Axis camera models using the H.264 format, visit the Axis product selecto

5 3. Setting up a PC This section describes how to assign a dedicated IP address to a PC. In this example, a Windows 7 PC is used. 1. Access [Start

6 5. Select [Internet Protocol Version 4 (TCP/IPv4)] and click on [Properties]. 6. Fill the IP fields as shown below. 7. Click on [OK] to confirm a

7 4. Setting up Axis IP Camera 4-1. Setting up IP Address of Axis IP Cameras To work with NavNet TZtouch, Axis IP cameras need to be set up with sp

8 4. Install the AXIS IP Utility program on your PC. 5. Double-click on [AXIS IP Utility] to open the program. The following window will open, show

9 8. Verify the IP address was successfully updated. 9. Repeat this process with all of the other camera(s). 10. After the IP addresses have been