Axis 250S Manuel d'utilisateur télécharger pdf (Page 46)

Unit Connections AXIS 250S User’s Manual

Appendix E - Unit Connections

The D-Sub Connector

The AXIS 250S provides one 9-pin D-sub connector, providing the physical interface for an

RS-232 port, used for connecting accessory equipment; such as stand-alone Pan/Tilt

devices for the remote positioning of connected video cameras.

A diagram of the RS-232 connector, complete with pin assignment table, is shown below.

The I/O Terminal Blocks

The two 4-pin I/O Terminal Blocks, A and B, are located on the rear panel and provide the

interface to: a single transistor output, four digital inputs, an RS-485 interface and GND.

This section describes the pinout, interface support and the control and monitoring

functions provided by the terminal blocks.

Note that the wiring for the pins on incoming plug connectors is not identical, but instead

on opposite sides in relation to each other. Check the rear panel before wiring.

Connector Pinout - Terminal Blocks A & B

Pin Function

1 CD

2 - RXD

3 - TXD

4 DTR

5 GND

6 DSR

7 RTS

8 CTS

9 RI

Pin Function Description

A1 GND

A2 Digital Input 1 To activate, connect to GND.

A3 Digital Input 2 To activate, connect to GND.

A4 Digital output With a maximum load of 100mA and maximum voltage of 24V DC, this

output has an open-collector NPN transistor with the emitter connected

to pin 1. If it is to be used with an external relay, a diode must be con-

nected in parallel with the load for protection against any voltage tran-

sients.

B1 Digital Input 3 To activate, connect to GND

B2 Digital Input 4 To activate, connect to GND

B3 RS485A RS-485/422 - A (non-inverting). A half-duplex RS-485/422 interface for

controlling auxiliary equipment.

B4 RS485B RS-485/422 - B (inverting)

54321

6789

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 56 57

Pas de commentaire

Axis 250S Manuel d'utilisateur Page 46