Axis BTA 2100D Manuel de l'opérateur télécharger pdf (Page 294)

100

101

292

ECD Detector

If you indicate that an ECD Detector is installed, an Oven Power switch, an

Electronics switch, and a Temperature setting will appear in the top portion of the

window, and additional detector adjustments will appear below the spreadsheet.

If you indicate that an ECD Detector is to be turned on and heated, select the

desired Temperature setting.

Indicate whether you will use the installed Detector Oven and Electronics by

clicking on the “On” or “Off” radio buttons.

You can time-program the detector range and autozero in the spreadsheet.

Select the desired ECD Time Constant by clicking on the “Slow” or “Fast” radio

buttons.

Select the desired Make up gas flow rate.

Select the desired Cell Current and Contact Potential from the available choices.

The first row of the spreadsheet contains the Initial Range and Autozero for the

ECD Detector. The ECD will switch to this setting when the method is activated,

and will be restored to this setting when each chromatographic run is completed.

Rows after the first row of the spreadsheet contain the time-programmed settings

for the Range and Autozero. They will be switched to the value in each row at the

indicated time.

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 596 597

Commentaires sur ces manuels

Pas de commentaire

Axis BTA 2100D Manuel de l'opérateur Page 294

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Axis BTA 2100D